RUDDER

01Rudder – First part I glued up was the rudder spar, just to get used to the gluing process and check out the T-88 epoxy. Ended up making up second part, since I didn't like the quality of the first. This is the second one!

02 Rudder – Initial layup of top rib, bottom rib and trailing edges, on top of rudder spar. Note ply alignment jig holding top rib at proper angle to the rudder spar

03 Rudder – Once initial layup dried, fit in remaining ribs as well as hinge point build-up pads.

04 Rudder – edges skinned, radii sanded, awaiting hinges and hanging on fuselage. This skinning process was good training for the skarfing and clamping processes which would be necessary for the wing. I actually built the rudder after making the wings, but it is a good place to start and learn good techniques.